TP-Link Cable/DSL Router TL-R860 - Manual (Page 41)

TL-R860 Cable/DSL Router User Guide
- 35 -
To add static routing entries:
1. Click
the Add New button. (pop-up Figure 4-35)
2. Enter the following data:
¾
Destination IP Address - The Destination IP Address is the address of the
network or host that you want to assign to a static route.
¾
Subnet Mask - The Subnet Mask determines which portion of an IP Address is the
network portion, and which portion is the host portion.
¾
Gateway - This is the IP Address of the gateway device that allows for contact
between the router and the network or host.
3. Select Enabled or Disabled for this entry on the Status pull-down list.
4. Click the Save button to save it.
Figure 4-35 Add or Modify a Static Route Entry
To modify or delete an existing entry:
1. Click
the Modify in the entry you want to modify. If you want to delete the entry, click
the Delete.
2. Modify the information.
3.
Click the Save button.
Click the Enable All button to make all entries enabled.
Click the Disabled All button to make all entries disabled.
Click the Delete All button to delete all entries
4.9 IP & MAC Binding Setting
Figure 4-36 the IP & MAC Binding menu
There are two submenus under the IP &MAC Binding menu (shown in Figure 4-36):
Binding Setting and ARP List. Click any of them, and you will be able to scan or
configure the corresponding function. The detailed explanations for each submenu are
provided below.