TRENDnet TW100-BRM504 - Manual (Page 8)

Setup
11
If you can't connect
If the Broadband ADSL Router does not respond, check the following:
• The Broadband ADSL Router is properly installed, LAN connection is OK,
and it is powered ON. You can test the connection by using the "Ping" com-
mand:
• Open the MS-DOS window or command prompt window.
• Enter the command:
ping 192.168.0.1
If no response is received, either the connection is not working, or your
PC's IP address is not compatible with the Broadband ADSL Router's IP
Address. (See next item.)
• If your PC is using a fixed IP Address, its IP Address must be within the range
192.168.0.2 to 192.168.0.254 to be compatible with the Broadband ADSL
Router's default IP Address of 192.168.0.1. Also, the Network Mask must be
set to 255.255.255.0. See Chapter 4 - PC Configuration for details on check-
ing your PC's TCP/IP settings.
• Ensure that your PC and the Broadband ADSL Router are on the same network
segment. (If you don't have a router, this must be the case.)
Setup Wizard
The first time you connect to the Broadband ADSL Router, you should run the Setup Wizard
to configure the ADSL and Internet Connection.
1. Click the Setup Wizard link on the main menu
2. On the first screen, select VC 1 (Router - Primary Internet Connection), then click "Next"
Figure 5: Setup Wizard Home Page
3. On the VC1 screen, shown below, enter the VPI and VCI values provided by your ISP,
then click "Next".
Broadband ADSL Router User Guide
12
Figure 6: Setup Wizard - VC1
Figure 7: Setup Wizard - Internet Access
4. On the Internet Access Screen, shown above, select the correct connection type, as used
by your ISP. Click "Next" and complete the configuration for your connection method.
• You need the data supplied by your ISP. Your ISP's data will also have the DSL Mul-
tiplexing Method ( LLC or VC )
• The common connection types are explained in the following table..