Toshiba SD-P120DTKE - Manual (Page 26)

26
Preparations
Preparation of the remote control
Insert the specifi ed battery in the remote control. See
page 8 , 9 for safe use of coin-shaped batteries.
1
Gently insert a fi ngernail in groove 1
and pull out the holder in direction 2.
Take care not to break your fi ngernail.
2 Place a coin-shaped
battery (CR2025) with the
side up on the holder.
Keep the holder horizontal so that
the battery does not fall through.
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the same or
equivalent type.
3 Insert the holder into the remote control.
The remote control battery contains Perchlorate
Material - special handling may apply.
Operating with the remote control
Point the remote control at the remote sensor at a right
angle to the LCD and press the buttons.
Distance: About 3 m (9.9 feet) from
the front of the remote
sensor
Angle: About 30° in each
direction of the front of the
remote sensor
Do not expose the remote sensor of the player to a
strong light source such as direct sunlight or other
illumination. If you do so, you may not be able to operate
the player via the remote control.
• Aim the remote control at the remote sensor of the player.
• Do not drop or give the remote control a shock.
• Do not leave the remote control near an extremely hot or humid place.
• Do not spill water or put anything wet on the remote control.
• Do not disassemble the remote control.
• If the remote control does not function correctly or if the operating
range becomes reduced, replace the battery with new one.
• Inserting a battery other than the specifi ed one or an object may
damage the remote control.
    2 #
6 
1
2
Within about 3 m (9.9 feet)
Backside