TANDBERG 150 - Manual (Page 21)

2 General Use
19
2.4.3 Call Settings
The field on the right in the call menu displays Call Settings. Call Settings gives you the
opportunity to specify Call Type and Bandwidth.
How to use Call Settings:
1. Press the green key on the keypad (or any of the other possibilities mentioned in
chapter Make a Call) to open the Call menu.
2. Move the orange selector to the Call Settings field on the right of the call menu and
press OK.
3. Make desired changes to Call Type and Bandwidth.
4. Press OK to save. The new call settings will be displayed in the Call settings field.
Call Type
Call Type can be set to Video Call (default) or Telephone Call. Using
Video, the system will try to connect as a video call. Some network
configurations will cause the fallback to a telephone call to fail. In these
cases, you should set the call type to telephone and the call will be placed
as a telephone type only.
Bandwidth
Bandwidth decides the quality of the video picture. The system will, by
default, connect using Auto Bandwidth. This means that the system will
establish a connection using a proper bandwidth for your call. The typical
bandwidth used for IP calls is 384kbps. When bandwidth is set to auto, the
unit will default to 384kbps.
Use Set as
Default If you want to change the default Call Settings, make the desired changes
to the Call Settings and Press Set as Default. Press OK to Save. These
settings will now be the default settings for all future manually dialed calls.