Tandy ET-539 - Manual (Page 9)

9
4. Align the tabs on the bracket with
the slots on the back of the base
and push up on the bracket until it
snaps in place.
Note: If you later want to remove
the bracket, press
PUSH and slide
the bracket down to remove it
from the base's bottom.
5. Insert the supplied AC adapter's
barrel plug into the 12V DC jack on
the back of the base. Then route
the adapter's cord around the
strain relief and through the right
slot on the base's bottom and
under the clips.
6. Plug the adapter into a standard
AC outlet.
7. Align the keyhole slots with the
mounting screws and slide the
base downward to secure it.
8. Press and lift out the handset
holder. Rotate the holder 180
degrees as shown, and then snap
it back into place so it holds the
handset.
9. Fully extend the base’s antenna
and place it in a vertical position.
(Illus with
callout:
AC Adapter)
(illus with
callout: Lift)
43-1039.fm Page 9 Tuesday, August 17, 1999 10:12 AM