Toshiba RD-X2U - Manual (Page 38)

38
To stop recording
Press the STOP button.
To pause recording (to omit an unnecessary
portion)
During recording, press the PAUSE button.
To resume recording, press it again.
Note
• Pausing recording automatically creates a new chapter at
that point.
To stop a programmed recording
To finish,
Press the button on the front panel twice.
When you press it once, a message appears. While
the message is displayed, press the button once
again.
(This operation is not applicable while a menu is
displayed.)
To pause recording,
Press the button on the front panel.
To resume recording, press it again.
To change a TV channel to be recorded
1) During recording, press the PAUSE button.
Recording pauses.
2) Press the CHANNEL buttons to change the
channel.
3) Press the PAUSE button to resume recording.
To view a TV program while recording another
1) Start recording on this recorder.
2) On a connected TV, select the TV mode.
3) Using the channel selector of the TV, select a
desired channel on the TV.
To reduce noise on recordings (Rec DNR)
Before recording, select “Rec DNR” from the setup
display.
page 129.
To record and play at the same time
To start recording while playing a disc
Stop playback, then select the other disc by
pressing the HDD or DVD button, and start
recording on that disc.
To play a disc while recording on another disc
Select the disc that is not being recorded by
pressing the HDD or DVD button, and start
playback on the disc.
To set an end time while recording is in progress
1) During recording, press the QUICK MENU
button.
The Quick Menu appears.
2) Press the / buttons to select “End Time”
then press the ENTER button.
The display changes as follows:
3) Press the / buttons to select an item then
press the ADJUST button to change the value.
4) Press the ENTER button.
Note
• By setting an end time, it is memorized as a programmed
one, and the indicator in the display section illuminates
to indicate that the recorder keeps an entry of recording.
• You cannot change the end time, once the setting is
completed.
• The programmed end time must be set for after 5 minutes
from the current time.
To turn the power off automatically after
completing a programmed recording
1) While performing a programmed recording,
press the QUICK MENU button.
The Quick Menu appears.
2) Press the / buttons to select “Auto Power
Off” then press the ENTER button.
Tips on recording
e.g.
PM 2 :13 End Time
*RD-X2.Ope(US)p027-044 9/3/02, 11:23 AM 38