TANDBERG D1320202 - Manual (Page 10)

TANDBERG GW Data port Command Interface User Guide
10
• DNS Server: Number identifying one of 5 DNS servers which
can be configured. If this parameter is omitted the command
applies to the first configuration (1).
sub-commands:
• Assignment: Selects between DHCP (Dynamic Host
Configuration Protocol) or static IP address allocation. When
DHCP is selected the GW will automatically receive all the
necessary information from the DHCP server. This function
should be used when the GW is connected to a LAN using
DHCP. When using this mode, IP-address and IP-subnet mask
are not used because the DHCP server supplies these parameters.
• Address: Sets the static IP address for the given LAN interface.
• Subnetmask: Sets the subnet mask variable. Subnet mask
defines the network class. If the setting is 255.255.255.0 the local
network will support up to 256 nodes, denoting a class C
network. If the setting is 255.255.0.0 the local network is a class
B network with 65536 addressable nodes.
• Gateway: Sets the gateway IP address. If a gateway is located on
the LAN and the GW needs to reach nodes through this gateway,
the gateway address can be set using the gateway variable (the IP
address of the gateway will be set automatically if the GW is in
DHCP mode)
• Domain Name: Sets the domain name string of which the
gateway is part of. Minimum 0, maximum 64 characters.
Example of IP Address feedback:
*c xConfiguration IP Address: "127.0.0.1"
Ethernet Sets LAN port speed.
NOTE! The GW needs to reboot before the changes will apply.
Ethernet <speed>
---
parameters:
• speed: auto/10half/10full/100half/100full. The speed is either
set to auto or manually from 10mb half duplex to 100mb full
duplex. When set to auto the GW will automatically negotiate
with the network and use the best available setting.
Example of Ethernet feedback:
*c xConfiguration Ethernet Speed: Auto
ISDN Defines various ISDN protocol settings.
ISDN IncomingBearerCapability: <UDI/All>
or
ISDN OutgoingBearerCapability: <H324m/UDI>
or
ISDN BRI SwitchType: <NI/ATT/Euro/Japan>
or
ISDN PRI SwitchType: <NI/ATT/Euro/Japan>
or
ISDN PRI Interface LowChannel: <1..31>
---
Parameters:
sub-commands: