Texas Instruments TVP5146EVM - Manual (Page 15)

SLEU063
TVP5160EVM User’s Guide 15
8 WinVCC4 in Depth
The following describes how to use WinVCC4 in depth. It discusses various features and
screens which the user m ay encounter while evaluating the TVP5160EVM.
8.1 Starting WinVCC4
The Port95NT parallel port driver must be installed before using WinVCC4. WinVCC4 may be
started by clicking on Start->All Programs->TVP5160EVM Software->WinVCC4.
If the dialog shown in the figure below is displayed, it means one of two things:
1. WinVCC4 did not run to completion the last time it ran. In this case, click OK to exit
the program and restart WinVCC4.
2. There is more than one instance of WinVCC4 running at the same time. In this case,
click OK to exit the program. Then, press CTRL-ALT-DELETE to bring up the Task
Manager. Select and click End Task on all occurrences of WinVCC4 or WinVCC4
CONFIGURATION. Then restart WinVCC4.
Figure 7. WinVCC4 Multiple Occurrences Error Message