Texas Instruments CC2533 - Manual (Page 22)

swru266
22/25
8 Appendix B: How to upgrade the target module USB driver
The target module USB driver information is stored an EEPROM for the TUSB3410 USB
interface device. This EEPROM includes Vendor ID, USB ID, USB device name, and serial
number. The EEPROM can be customized by programming the EEPROM via the USB
interface.
To modify the EEPROM content, download the EEPROM burner SW:
http://www.ti.com/lit/zip/sllc259 . Install the program on the PC
Remove the CC2533EM from the target module and short the pins 1(GND) and pin 11(I2C
SDA) on the interface header to short the EEPROM data signal to GND. Plug in the mini-USB
connector.
Figure 16: Short pin 1(GND) and pin11 (SDA)
The device should now identify as a TUSB3410 device on the PC, and the new hardware
wizard will be displayed. If the wizard is not displayed, go to “Control Panel -> System ->
Device Manager -> Port (COM & LPT) right click on the TUSB3410 Device driver and select
“Update Driver”.
Figure 17: Installing the EEPROM burner driver
The device should now be appearing as an EEPROM burner device in the USB devices
device list.
Start the EEPROM burner software, select the TUSB3410 EEPROM Burner devices from the
device list, 128Kb EEPROM size and load the file
<Installation path>\Tools\Driver\ RemoTI_TUSB3410_serialized.bin