Texas Instruments TM5000 Series - Manual (Page 104)

Startup Error Messages
Diskette drive 0
failure Press Ctrl-Alt-Esc to ensure that the
drive type is set correctly in Setup
(should be 3.5 inch, 1.44 MB).
Diskette read
failure - press F1 to
retry boot Floppy defective or unformatted; insert a
different floppy and press F1.
Fixed disk failure Turn the computer off; wait several
seconds; then turn the computer on
again.
Press Ctrl-Alt-Esc to ensure hard disk
type is correct in Setup (should be the
default for the internal hard disk).
Fixed disk read
failure - press F1 to
retry boot Press Ctrl-Alt-Esc to ensure hard disk
type is correct in Setup (should be the
default for the internal hard disk).
Invalid
Configuration
Information Defaults in Setup may have changed.
Enter Setup and press Esc-F5 to reset
defaults. Then press Esc-F4 to save
and reboot.
Battery that maintains configuration
has failed; follow procedure in this
chapter to restore configuration.
Keyboard
clock/data line
failure Ensure external keyboard connected
correctly.
Replace external keyboard.
Keyboard stuck
key failure Press jammed key to unstick it
Ensure no keys pressed during
computer startup.
Missing operating
system
Press Ctrl-Alt-Esc to ensure the hard
disk is defined correctly in Setup.
Reboot using the System Files Recovery
diskette.
Startup Error Messages
7-4