Tyco 0-1591099-x - Manual (Page 9)

24 Port Stackable Managed Switch – User Guide Page 9
Rack-mounted Installation
The 24 Port Stackable Managed Switch is supplied with a rack-mounted kit and can be
mounted in an EIA standard size, 19-inch rack. The Switch can be placed in a wiring closet
with other equipment.
Perform the following steps to rack mount the Switch:
Position one bracket to align with the holes on one side of the Switch and secure it with the
smaller bracket screws. Then attach the remaining bracket to the other side of the Switch.
Figure 6. Attach mounting brackets with screws
After attaching both mounting brackets, position the Switch in the rack by lining up the holes
in the brackets with the appropriate holes on the rack. Secure the Switch to the rack with the
rack-mounting screws.
Figure 7. Mount the Switch in an EIA standard 19-inch Rack
NOTE: For ventilation allow at least 4 inches (10 cm) of clearance on the front and
3.4 inches (8 cm) on the back of the Switch. This is especially important for enclosed
rack installation.
Product Number 0-1591099-x © Tyco Electronics 2005 Issue 1