Trust Computer Products 140BM - Manual (Page 6)

TRUST 140BM LCD WIRELESS OBSERVATION SYSTEM
Item Description Comments
A Level button Sets the sound level for the Auto mode. When
using the Auto mode, the monitor turns on
automatically when the set sound level is
exceeded.
B Power/volume button Turns the sound on and off and adjusts the
sound level.
C Auto switch Turns the Auto mode on and off.
D Channel indicator Lights up for the chosen channel.
E Power indicator Is lit when the monitor has been turned on.
F Channel selection
switch
G Brightness buttons Adjusts the brightness.
H Attachment points Use these to attach the monitor to an
attachment plate or wall.
I Battery cover If necessary, insert four AA batteries here.
U K
Table 3: Monitor components
The camera settings and options are given in table 4 and figure 4.
Item Description
Comments
J Infrared LED’s Makes it possible to receive clear
images in dark conditions when in the
Night mode.
K Lens Records the image.
L Lens ball Used to alter the vertical viewing
angle.
M Microphone Records the sound.
N Attachment points Use these to attach the camera to an
attachment plate or wall.
O Battery cover If necessary, insert four AA batteries
here.
Table 4: Camera components
4.2 Inserting the batteries (optional)
You can use batteries (not included) if you do not wish or are not able to use the
power adapter for the camera or the monitor. Use AA batteries.
1.
Remove the battery cover (A) on the rear of the monitor or the rear of the
camera (see figure 5).
2. Insert the batteries as indicated inside the battery compartment (B).
3. Close the battery flap.
Note: Inserting the batteries incorrectly may cause damage.
Only use alkaline or rechargeable NiMH batteries (type AA). The
image quality and the transmission range are reduced when the
battery power is reduced. It is, therefore, recommended to use the
power adapter whenever possible.
If you use batteries, it is recommended to change these or charge
them regularly.
3