Trust Computer Products 140BM - Manual (Page 8)

TRUST 140BM LCD WIRELESS OBSERVATION SYSTEM
signal. Therefore, in order to have the best possible reception, try to avoid
these obstacles as much as possible.
2. People walking near the transmitter or receiver (particularly between the two)
may also reduce the quality of the reception.
U K 3. Try to achieve the best possible reception by positioning the camera and the
monitor correctly in relation to each other. Both devices have built-in aerials.
The aerials can be directed by moving the devices.
4. The device may be affected by external sources of interference, such as
microwave ovens, the weather and other devices which use the same
frequency as this device. If possible, turn these devices off when using the
TRUST 140BM LCD WIRELESS OBSERVATION SYSTEM.
4.7 Expanding the wireless security system
If you have several black-and-white or colour cameras and/or receivers, you can use
these to expand your wireless system. For these additional cameras and/or receivers
to function correctly, they must to be connected to the system and operate on the
same frequency (signal). A maximum of 3 wireless cameras can be connected to the
monitor. There is no theoretical limit to the number of receivers which can be added
to the system.
This monitor is ideal for use with other TRUST CONVENIENCE products. See the
Trust website (www.trust.com) for more information. When a number of cameras are
connected to this monitoring system, you must manually switch between the
channels.
5 Troubleshooting
Problem Cause Possible solution
The power supply has not been
connected. Check whether the power
supply has been connected
to the monitor and the
camera correctly.
The batteries have been
inserted incorrectly. Reinsert the batteries
The batteries in the camera
and/or the monitor are empty. Replace the batteries.
Another RF device is operating
on the same channel as the
TRUST 140BM LCD
WIRELESS OBSERVATION
SYSTEM. Change the channel of both
the camera and the receiver.
Change the physical location
of the camera (transmitter)
and/or the receiver by
altering the direction or the
distance.
The camera is set up in a dark
room and the Night mode has
not been selected.
Select the Night mode on
the camera.
No image on the
monitor.
The monitor has been set to
the Auto mode. Turn off the Auto mode or
adjust the noise sensitivity
level.
5