Texas Instruments SLOU121 User Manual

Page 15

Advertising
background image

Quick Start List for Platform

2-3

Quick Start

2.2

Quick Start List for Platform

Follow these steps when using the TPA6011A4 EVM with the TI plug-n-play
audio amplifier evaluation platform (see the platform user’s guide, SLOU011,
for additional details). Numbered callouts for selected steps are shown in
Figure 2–1 and Figure 2–2, and details appear in Chapter 3.

-

Platform Preparations

1) Ensure that all external power sources are set to OFF and that the platform

power switch S1 is set to OFF.

2) Install a TPA6011A4 module in platform socket U2, taking care to align the

module pins correctly.

3) Use switch S2 to select or bypass the signal conditioning EVM (U1).

4) Set control signal polarity jumper JP8 to Hi.

5) Set jumper JP6 to select the Mode control input (causes the TPA6011A4

to switch to the single-ended output mode if a plug is inserted into platform
headphone jack J10).

6) If the headphone jack (J10) output will be used, set headphone source

switch S3 to U2– U4.

Table 2–3. Platform Jumper and Switch Settings for the TPA6011A4

EVM

JP6

JP7

JP8

S2

S3

P-N-P Platform

Mode

X

Hi

Note 2

U2–U4

Notes:

1) X = Don’t care
2) Set S2 to ON when signal conditioning board is installed in U1; set S2

to OFF when no signal conditioning board is installed.

-

Power Supply

7) Select and connect the power supply (ensure power supply is set to OFF ):

a) Connect an external regulated power supply set to 5 V to platform V

DD

power input connector J6 taking care to observe marked polarity,
or

b) Install a voltage regulator EVM (SLVP097 or equiv.) in platform socket

U6. Connect a 7 V – 12 V power source to a platform V

CC

power input

J1 or J2 and jumper the appropriate power input (see platform user’s
guide).

-

Inputs and Outputs

8) Ensure that the audio signal source level is set to minimum.

9) Connect the audio source to left and right RCA phono jacks J3 and J5 or

stereo miniature phone jack J4.

10) Connect speakers to left and right RCA jacks J7 and J9 or to stripped wire

speaker connectors J8.

-

Evaluation Module Preparations

Advertising