Texas Instruments SLOU121 - Manual (Page 37)

Using the TPA6011A4 EVM Stand-Alone
3-17 Details
3.4 Using the TPA6011A4 EVM Stand-Alone
Using the TPA6011A4 audio power amplifier evaluation module stand-alone
is much the same as using it with the platform. The same 4.5-V to 5.5-V power
supply range and the isolated OUT+ and OUT– lines for BTL operation
requirement exists.
Note that the shutdown signal applied to the EVM SHUTDOWN pin must be
able to supply enough current to overcome the pullup resistor on the module
(100 k
Ω
).
3.4.1 TPA6011A4 EVM Connected for BTL Output
Figure 3–10. TPA6011A4 EVM Connected for Stereo BTL Output
External Shut
Down Control
(active low)
Right
Left
Audio
Input
(Right)
Audio
Input
(Left)
5 V
Table 3–3. Typical TPA6011A4 EVM Jumper Settings for BTL Stand-Alone
EVM S3
TPA6011A4 OFF
Note: ON = Shunt installed
OFF = Open