Topcom BUTLER 4800 - Manual (Page 14)

14 Topcom Butler 4800/Twin/Triple/Quattro
Topcom Butler 4800Twin/Triple/Quattro
7.3 Calling a number from the Call list
Scroll through the Call list until the desired number is shown on the display. Æ Press the
Line button . The number will be dialled automatically.
7.4 Erasing a number from the Call list
Scroll through the Call list until the desired number is shown on the display. Æ Press the
Mute button and OK to erase the number.
7.5 Erasing all numbers from the Call list
You can only erase all numbers from the call list if all are read.
Press and hold the Mute/Delete button until ‘Delete All’ appears.
Æ Press the Menu/OK
button to confirm or Mute/Delete button to cancel.
7.6 Store a number from the call log into the phonebook memory
Scroll through the Call list until the desired number is shown on the display. Æ Press the
Phonebook button . Æ Edit or enter the name and press OK Æ Edit or enter the telephone
number and press OK again to confirm and to go back to the call list.
8 Register/de-register a handset
8.1 Register to a Topcom B4800 base
You can subscribe 4 handsets to one base unit. By default, each handset is subscribed as
handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if:
•
The handset subscription has been removed from the base unit (e.g. for reinitialisation)
• If yYou want to subscribe a different handset to this base unit.
The below procedure is only applicable to a Topcom Butler 33xx handset and base unit!!
Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator
on the base unit begins to blink rapidly. The Line/Charge indicator will blink rapidly for one
minute. During this minute, the base unit is in register mode and you must do the following
to subscribe the handset:
Press Menu button
ÆUse the Right button to scroll to ‘REGISTER’ and press OK
Æ Enter the number of the base unit you would like to subscribe the handset to (1-4) Æ The
unit will start searching for the base and when found it will ask to enter the pin code (4 digits):
Æ Enter the base pin code (0000) and press OK
. Æ If the pin is wrong, the handset will
restart the searching for the base. Æ When the handset is registered, it will show ‘HS’
followed by the handset number.