Toshiba IK-52N - Manual (Page 5)

4
Rear Side
ON OFF
EXT INT
HD/VD
75 Ω
SHT
TRG
M.G
MIN MAX
M GAIN
VIDEO OUT
DC IN/SYNC
FRM
Enlarged
1 VIDEO OUT DC IN/SYNC plug (12-pin connector)
This receives +12 VDC, and sends a video signal from the camera. When a synchronizing signal
generator is connected to this plug and an external synchronizing signal (HD/VD signal) is applied,
the camera can be operated synchronously with the external signal.
2 75
Ω
terminal switch (Terminal of external synchronizing HD/VD input signal)
Set this switch to OFF when not terminated. The factory setting is ON.
3 HD/VD signal input/output selector switch
Set to INT to output the HD/VD signals from the camera, and EXT to input external HD/VD signals.
The factory setting is EXT.
4 MODE SELECT switch
1 Shutter speed setting (MODE SELECT switch bit 1 to 4)
Set to the shutter speed suitable for the shooting conditions. For each setting position, refer to
P. 7. The factory setting position is shutter OFF.
2 Reset restart/External trigger mode setting (MODE SELECT switch bit 5 to 7)
For each setting position, refer to P. 8 to 13. The factory setting position is NORMAL.
3 Trigger polarity setting (MODE SELECT switch bit 8)
Selects the polarity of an externally inputted trigger.
OFF: Positive ON: Negative
The factory setting position is OFF.
4 Field accumulation/Frame accumulation setting (MODE SELECT switch bit 9)
For the mode setting, refer to P. 6. The factory setting position is Field accumulation.
5 Gain selector switch setting (MODE SELECT switch bit 0)
This switch selects the modes OFF (fixed) or ON (manual). The factory setting is OFF (fixed).
5 Manual gain (M GAIN) control knob
This adjusts the gain of a video signal when the gain mode is set to ON by the MODE SELECT
switch bit 0 on step
5 . The factory setting is the fully counterclockwise position.