Thecus Technology M3800 - Manual (Page 17)

RAID Setup and Firmware Installation
Once the setup wizard has completed, you should now be inside the Web Admin
Interface. From here, it is time to initialize your RAID system and install the
firmware for the M3800.
The next steps are for first time setup only. If you have previously setup your
M3800, you can skip this section of the setup process.
NOTE
Setting up the RAID
1. From the Web Admin Interface, navigate to Storage > RAID. The RAID
Information screen appears.
Click Config.
2. Select your desired RAID level, and check the checkboxes of the disks you
wish to use in your array.
3. Select a stripe size – the default is 64K.
4. Click Create to create your selected RAID volume.
17