Tonino Lamborghini Espresso Maker User Manual
Page 16
16 –
T
T
O
O
N
N
I
I
N
N
O
O
L
L
A
A
M
M
B
B
O
O
R
R
G
G
H
H
I
I
N
N
I
I
E
E
P
P
S
S
Use and maintenance manual – Rev.01 - 07/2006
hand side of the casing and the single
button on the left hand side are NOT
depressed. Push the buttons in with your
finger to ensure that they are not
depressed.
2 Plug in the mains cable to a suitable wall
socket. Turn on the wall socket.
3 Turn on the coffee machine by pressing in
the on/off button which is located on the
right hand side of the casing above the
water button.
4 Close the pod assembly by pushing the
gearlever away from you until it locks into
position.
5 Press in the water button and you will hear
the pump running. Wait until water starts to
come out of the spout (see also note
below).
6 Press the water button again to stop the
water flow.
7 The machine is now primed and ready for
use.
NOTE: If after a few seconds the pump is
running but no water appears at the spout, switch
off the machine and retry after a few minutes or
just open the steam release knob for a few instant
and retry.
ATTENTION: If you leave the machine turned
on without any water being present in the
boiler for a period of time it will cause
irreparable damage which is not covered by
the guarantee.
4.3. MAKING A CUP OF COFFEE
To make a cup of coffee with your Tonino
Lamborghini machine proceed as outlined below:
1. Before plugging the mains cable in ensure
that the two buttons on the right hand side
of the casing and the single button on the
left hand side are NOT depressed. Push the
buttons in with your finger to ensure that
they are not depressed.
2. Plug in the mains cable to a suitable wall