Tonino Lamborghini Espresso Maker User Manual
Page 24
24 –
T
T
O
O
N
N
I
I
N
N
O
O
L
L
A
A
M
M
B
B
O
O
R
R
G
G
H
H
I
I
N
N
I
I
E
E
P
P
S
S
Use and maintenance manual – Rev.01 - 07/2006
with a Microfibre cloth for cleaning the external
chrome and polished steel surfaces. First clean the
parts with a damp sponge or wet cloth before
drying off with a soft cloth. Finally polish the parts
with the Microfibre cloth. The Microfibre cloth is
ideal for removing fingerprints. Do not use the
microfibre cloth on the black painted surfaces.
6.5. CLEANING THE PAINTED SURFACES
It is only necessary to use cold water and a
mild detergent to clean the sides of the coffee
machine.
However, please note:
1 When cleaning the machine keep the
machine out of direct sunlight and make
sure the temperature is below 30 degrees C.
2 Do not use steam from the machine to clean
the surfaces.
3 Use only mild detergents
4 Do not use abrasive materials that may
damage the paint
5 Clean a small section of the surface to start
with to ensure that there is no adverse
effect on the metal before cleaning the
whole machine.
6 After using a mild detergent always wash it
off with clean, cold water.
6.6. CLEANING THE WATER RESERVOIR
Periodically it is advisable to remove the
water reservoir from the machine and to wash it in
cold water. Do not use detergents to clean the
inside of the water reservoir. The water used in the
reservoir should be cold and ideally filtered or
bottled (still) water.
6.7. REPLACING THE POD ASSEMBLY RUBBER SEALING
RING
After making about 1000 cups of coffee it will
be necessary to replace the orange rubber sealing
ring above the pod holder assembly. Two spare
seals are supplied with the machine. (see par. 1.1).
To change the seal proceed as follows: