Tekxon Technology MegaCam - Manual (Page 7)

7
Note: 1. To remove the SD card, push
the SD card once and the card will be
ejected from the memory compartment.
2. MegaCam comes with built-in 8Mbyte
internal NAND Flash memory. You don’t
necessarily add extra memory for it.
• Step 3 Attach the wrist strap to the strap
holder at the side of the camera as
illustrated in the picture below.
Start Using Your Camera
• Step 1 Press the Power button to
turn on the camera. A green light just
beside the Viewfinder then lights up.
• Step 2 The LCD Display will be turned
on automatically.
Preparing Your Camera
• Step 1 Insert the two AA batteries into the
battery compartment located at the bottom
of your digital camera. When closing the
battery door, push the battery door down
and then slide it closed.
• Step 2 Open the memory compartment
cover located at the bottom of your
camera and insert the SD memory card.
When inserting, hold the memory card so
that its pin connector is pointing towards
the camera. Also, the front side of the
memory card should be facing the front
side of the camera.
Then, push the memory card all the way
into the memory compartment and close
the cover.