TravRoute CoPilot 2002 - Manual (Page 2)

CoPilot ® 2002 Quick Start
If you're in a hurry to begin using CoPilot 2002:
1. Install Application: Boot up your computer. After Windows ® (95, 98, NT ® , 2000,
ME ® ) has finished booting up, install CoPilot 2002 by placing the Install CD
into your CD-ROM drive. Select Install CoPilot from the pop-up menu and follow
the on-screen instructions. (If the Installation menu does not automatically appear,
see Installation on page 5).
NOTE: You must uninstall any previous versions of CoPilot before installing
CoPilot 2002.
2. Install Speech: After CoPilot has been installed, you will be prompted to install
speech software. Click OK and follow the on-screen instructions.
NOTE: You must install speech to enable CoPilot's two-way voice technology.
3. Install Data: You can install either one or both Data CDs to your hard drive,
depending on your preference. To install both CDs will require about 1 GB of
space. Place the East or West Data CD into the CD-ROM drive and follow the
installation instructions.
4. Attach GPS Receiver: Plug the GPS receiver into your laptop (see page 9-10).
Serial: If you are using a GPS receiver with a serial connection, attach the
receiver to both the serial port and the PS/2 port.
USB: If you are using a receiver with a USB connection simply plug the
receiver into the USB port.
5. Verify Computer Settings: Make sure the date and time are set correctly on your
computer. This is extremely important for CoPilot to function properly. To
check and/or change the date and time, go to the Windows Start button, Settings,
Control Panel, Date/Time.