Topcom BUTLER 132 - Manual (Page 25)

25
Important : Memory number [0] has to be programmed for this function. This
function is not valid when “mem 0” is not programmed.
4.7 Mute function
It is possible to deactivate the microphone during a conversation. Now
you can speak openly without being heard by your correspondent.
• Press the Mute button during a conversation. The microphone will be
deactivated. The MUTE symbol appears on the display.
• P ress the Mute button again when you want to continue the conversa-
t i o n .
4.8 Paging
When you press the Paging button on the base unit, the handset emits a
ringing signal for 15 seconds. This signal helps you find a lost handset.
The PAGING symbol
blinks on the base unit. The message “bASE
PAGE” appears on the display.
4.9 Handset lock
When a particular number has been locked, every phone number, start i n g
with this number, will be blocked and cannot be called.
• Press the Set button.
• Press numerical button ‘8’.
• Enter the 4 digit PIN code (default 0000).
• Enter the number you want to lock (max. 3 digits). You can erase a
digit by means of the Mute button.
• Press the Memory button. The unit emits a confirmation tone.
Default setting : no handset lock.
As soon as you dial the blocked number, “barring” is shown on the display.
To remove a blocked number, follow the same instructions but erase the
blocked number by pressing the Mute button.
4.10 Keypad lock
When the keypad is locked, the keypad buttons can no longer be pre s s e d ,
except for the Set button.
• Press the Set button.
• Press numerical button ‘7’.
• Press numerical button ‘1’ to activate/deactivate this function.
• Press the memory button. The unit emits a confirmation tone.
• ‘On’ is shown on the display.
Default setting : no keypad lock.
As soon as this function is activated, [Hold] is shown on the display each
time a numerical button is pressed. Follow the same instructions to
deactivate this function.
Butler 132/137