Topcom BUTLER 132 - Manual (Page 27)

27
• Press numerical button ‘1’ to activate/deactivate this function.
• Press the Memory button. The unit emits a confirmation tone.
Default setting : off
Note : When a call comes in and the handset is not lying on the base unit, you
always have to press the Line button to accept the call, even when the function
‘Automatic answering’ is activated.
4.17 Default settings (Reset)
If you want to reset the default settings of the unit, please take the
following steps :
• Press the Set button.
• Press numerical button ‘0’.
• Enter the 4 digit PIN code.
• Press numerical button ‘1’ to select whether or not you want to reset
the default settings, indicated by (y) yes or (n) no.
• Press the Memory button. The unit emits a confirmation tone.
Note : When you reset the default settings, all memory numbers will be erased.
4.18 Programming the PIN code
When you change the PIN code, it is very important not to forget the
new PIN code !
• Press the Set button.
• Press button ‘#’.
• Enter the present 4 digit PIN code.
• Enter the new 4 digit PIN code.
• Press the Memory button. The unit emits a confirmation tone.
Default setting : ‘0000’
4.19 Caller-ID function (CLIP) (for the Butler 137 only)
The Butler 137 displays the telephone numbers of incoming calls. This
function is only possible if you are subscribed to a telephone operator
that provides this service. Contact your telephone provider for more
information. When you didn’t receive a call, the numbers are saved in a
call list. This list can hold 12 telephone numbers (each of max. 16 digits).
4.19.1 New calls
When you’ve received a new incoming call, the CLIP symbol appears
on the display and the green Reception LED on the base unit starts to blink.
Butler 132/137