Trust Computer Products Super G 802.11g - Manual (Page 12)

108Mbps SuperG Wireless PCI Adapter
12
Installation
This section shows you how to install the Utility if you are using the operating systems Windows
2000, ME, 98SE. Follow the instructions given below on how to install the hardware (The
108Mbps SuperG Wireless PCI Adapter) and then the software (driver and utility). For those
using Windows XP, the installation procedure will be the same until the utility installation.
Windows XP has a built in utility for wireless devices. The configuration utility does not need to be
installed for users using the XP operating system.
System Requirements:
• A laptop computer with an available PCI - 32-bit slot
• At least a 300 MHz processor and 32 MB of memory
• PCI bus Controller properly installed and working
• An 802.11b/g Access Point (for Infrastructure Mode) or another 802.11b/g wireless card
(for Ad-Hoc mode.)