Trust Computer Products Super G 802.11g - Manual (Page 9)

IEEE 802.11g PCI Card Wireless Network Adapter
9
(Requirements: A Residential Gateway/Router connected with an Ethernet (CAT5) cable to an
802.11a/b Access Point or an 802.11a/g Access Point or another computer with an 802.11b/g
WLAN card installed).
This type of installation requires that you provide a dynamic IP address for each computer on your
network. You will need a DHCP-capable Residential Gateway/Router for your network.
To complete the installation, please follow these steps:
1. Connect the Router/Gateway to a Broadband connection, (e.g., a Cable modem or a DSL
modem.)
2. Connect the WLAN Access Point to the router.
3. Install the 108Mbps SuperG Wireless PCI Adapter into a laptop computer on your
wireless network.
4. Check the Device Manager to confirm that the wireless card is installed correctly.
5. By default, the wireless card is set to obtain a Dynamic IP Address. If you are having
difficulty connecting, check to make sure that the IP Address of the wireless card is within
the IP address range of your network.
2. A Home Internet Network with Multiple IP Addresses
(Network administrators with Static IPs can also follow these instructions.)
If you have two or more computers (laptops or desktops) and want to share files, printers, and
Internet access using multiple IP addresses that you have purchased from your Internet Service
Provider
-or- you want to connect to an Ethernet network that uses Static IP Addresses, then
follow the instructions on the next page. When you have completed your network, it should look
similar to this: