Toro TMC-424E - Manual (Page 7)

4. Press the or button to adjust
the station run time from Off (-- -- --) to
8 hours (in 1-minute increments).
If seconds format is enabled, station run
time can be set from 01–60 seconds.
NOTE: Hold either button down for
rapid advance.
5. Repeat steps 3 and 4 for all stations to
be assigned to the selected program.
1. Set the Program Switch to select
program A, B, C, or D.
2. Turn Function Dial to Start Times .
The hour digits will begin flashing.
3. Press the or button to select
a start time number (01 to 16).
NOTE: Any start time number currently
assigned to another program can not be
selected. If all 16 start time assignments
are in use, NONE will be displayed.
4. Press the or button to select a start
time hour (note the correct a.m./p.m.
designation in the 12-hour clock mode).
NOTE: To remove a start time, select
-- --:-- -- (off), located between 11:00 p.m.
and 12:00 a.m. (00 minutes).
5. Press the button to select minutes
digits. Repeat step 4 to set start time
minutes (00–59).
6. Repeat steps 3–5 to set additional start
times for the selected program.
Set Program Start Time
7