Transition Networks CETTF10XX-105 User Manual
User’s guide
User’s Guide
CETTF10xx-105
Slide-in-Module Media Converter
• Ethernet
• Copper to Fiber
• 10Base-T to 10Base-FL
Transition Networks CETTF10xx-105 series Ethernet
10Base-T to 10Base-FL media converters (designed
to be installed in a PointSystem™ chassis) connect
10Base-T twisted-pair copper cable to multimode or
single mode 10Base-FL fiber-optic cable.
* CETTF1029-105 and CETTF1029-106 are designed to be installed in the same
network where one is the local converter and the other is the remote converter.
The distances listed are the typical maximum cable distance. Actual distance is
dependent upon the physical characteristics of the network installation.
Part Number
Port One - Copper
10Base-T
Port Two - Fiber-Optic
10Base-FL
CETTF1011-105
RJ-45
100 m (328 ft)*
ST, 850 nm multimode, duplex
2 km (1.2 miles)
CETTF1012-105
RJ-45
100 m (328 ft)*
ST, 1310 nm single mode, duplex
20 km (12.4 miles)
CETTF1013-105
RJ-45
100 m (328 ft)*
SC, 850 nm multimode, duplex
2 km (1.2 miles)
CETTF1014-105
RJ-45
100 m (328 ft)*
SC, 1310 nm single mode, duplex
20 km (12.4 miles)
CETTF1022-105
RJ-45
100 m (328 ft)*
ST, 1310 nm single mode, duplex
40 km (24.9 miles)
CETTF1027-105
RJ-45
100 m (328 ft)*
ST, 1300 nm multimode, duplex
5 km (3.1 miles)
CETTF1018-105
RJ-45
100 m (328 ft)*
MT-RJ, 850 nm multimode, duplex
2 km (1.2 miles)
CETTF1014-106
RJ-45
100 m (328 ft)*
SC, 1310 nm single mode, duplex
20 km (12.4 miles)
CETTF1015-105
RJ-45
100 m (328 ft)*
SC, 1310 nm single mode, duplex
40 km (24.9 miles)
CETTF1029-105*
RJ-45
100 m (328 ft)*
SC, 1310 nm (TX) / 1550 nm (RX)
single fiber, 20 km (12.4 miles)
CETTF1029-106*
RJ-45
100 m (328 ft)*
SC, 1550 nm (TX) / 1310 nm (RX)
single fiber, 20 km (12.4 miles)