Teledyne 3160 - Manual (Page 25)

Installation 3 Installation 3 Installation 3 Installation 3 Installation 3
3-7 TELEDYNE ANALYTICAL INSTRUMENTS
Figure 3-3: 3160 Rear Panel.
3.6.1 Voltage Selection
WARNING: Power cord must be disconnected before performing any voltage
selection!
The voltage setting and fuses of the analyzer can be changed to international
standards. To change the voltage setting or fuses:
1. Open the cover using a small blade screwdriver.
2. Remove the cover and the fuse block assembly.
3. Pull the voltage selector card straight out of the housing by pulling on the
indicator pin (see Figure 3–4).