TAG MIL-BOOK 10 - Manual (Page 99)

The PC Card stops communicating properly.
The application may have been reset when the computer is turned off
or in Standby mode. Exit and restart the application.
Power Management Problems (for Windows)
The computer does not enter Standby or Suspend mode
automatically.
If you have a connection to another computer, the computer does not
enter Standby or Suspend mode if the connection is actively in use.
Make sure that the Standby or Suspend time-out is enabled.
The computer does not enter Standby or Suspend mode
immediately.
If the computer is performing an operation, it normally waits for the
operation to finish.
The computer does not resume from Standby or Suspend mode.
The computer automatically enters Standby or Suspend mode when
the battery pack is empty. Do any one of the following:
− Connect the AC or car adapter to the computer.
− Replace the empty battery pack with a fully charged one.
The computer does not enter Suspend mode.
If you are using Windows 98, make sure that the Suspend-to-disk
partition or file exists.
You might be using a PC Card that prevents the computer from
entering Suspend mode. To enter the mode, stop the communication
program and then remove the card or stop the card.
Printer Problems
The printer does not work.
Make sure that the printer is turned on (if it comes with an
independent power source) and is online (ready to use).
Troubleshooting 8-11