TANDBERG 3.0 - Manual (Page 49)

Copyright © TANDBERG 2008 Reference Guide Version 3.0 rev 3.0 45
Response Type Comments
deferConnection Boolean
displayName
string The name used by the endpoint to identify itself.
This may be different to the participantName.
Only available after the participant has
connected.
displayNameOverrideStatus Boolean Indicates whether the displayName value is the
result of being overridden.
maxBitRateToMCU Integer
maxBitRateFromMCU Integer As for “participant.add”; in kbps.
callState String One of:
dormant
,
alerting
,
connected
or
disconnected
.
connectTime dateTime.iso8601 Only returned after the participant is connected.
This value is always present if the call state is
connected
; it may or may not be defined for
participants in the
disconnected
call state,
depending on whether they were ever
connected.
disconnectTime dateTime.iso8601 Only returned after the participant has
disconnected.
disconnectReason String Only returned after the participant has
disconnected, one of the disconnect reason
values given in section 12.
connectPending boolean true if a “participant.connect” command is
required for this participant. This parameter will
cause either the initial connection to that
endpoint (in the event that it was configured
with deferConnection set) or a re-connection to
that endpoint (in the event that it has
disconnected).
audioRxCodec String
audioRxLost Integer
audioRxReceived Integer
audioTxCodec String
audioTxReportedLost Integer
audioTxSent Integer
audioRxMuted Boolean
audioRxGainMode String
audioRxGainMillidB Integer
videoRxCodec String
videoRxLost Integer
videoRxReceived Integer
videoTxCodec String
videoTxReportedLost Integer
videoTxSent Integer
videoRxMuted Boolean
videoTxWidescreen Boolean
important Boolean
activeSpeaker Boolean true if this participant is currently the active
speaker in the conference.
layoutControlEnabled Boolean
cpLayout String The configured layout behavior for this