Teac SR-L70i - Manual (Page 24)

24
If you have problems with your system, read
this page and try to solve the problem yourself
before calling your dealer or TEAC service
center.
General
No power.
e Check the connection to the AC power
supply. Check whether the AC source is a
switched outlet or not and, if it is, that the
switch is turned on. Confirm that there is
power to the AC outlet by plugging
another item such as a lamp or fan into the
outlet.
e The fuse might be blown. Replace it with a
T2 AL 250V fuse. Do not use a different
t ype of fuse. Doing so could cause
excessive heat generation or other
abnormal behavior that could lead to
malfunction or fire.
No sound from speakers.
e Select the source by pressing the TUNER
button, the AUX button, or the iPod button
(y/J).
e Adjust the volume.
e Remove the headphone plug from the
PHONES jack.
Remote control does not work.
e Press the STANDBY/ON switch to turn the
unit on.
e If the battery is exhausted, replace it with a
new one.
e Use the remote control unit within the
operation range (5 yd) and point it at the
remote sensor on the front panel.
e Remove obstacles between the remote
control unit and the main unit.
e If a bright light is near the unit, turn it off.
Troubleshooting
The sound is noisy.
e The unit is too close to a TV or similar
device. Relocate the unit farther away from
such devices, or turn them off.
iPod Player
Cannot insert the iPod.
e Adjust the dock adapter.
e Remove dust or obstacles from the SR-L70i
dock connector and the iPod, and insert
the iPod again.
iPod will not play.
e Remove the iPod from the dock, wait a few
seconds, and insert it again.
e A sof t ware up date might solve the
problem. Visit the Apple website and
download the latest iPod Software.
Cannot operate the iPod.
e Turn off the HOLD switch of the iPod.
Tuner
Cannot listen to any station, or the signal
is too weak.
e Tune in the station properly.
e Move the antenna for FM or the main unit
for AM until you receive stations clearly.
If normal operation cannot be restored,
unplug the power cord from the outlet
and plug it in again.
Maintenance
If the surface of the unit gets dirty, wipe with a
soft cloth or use a diluted mild liquid soap. Be
sure to remove any excess liquid completely. Do
not use thinner, benzine or alcohol as they
might damage the surface of the unit. Allow the
surface of the unit to dry completely before
using it.