TEN Technology naviPlay Bluetooth Stereo Headset Kit for iPod - Manual (Page 17)

Setting up the naviPlay Headset to work with your mobile phone:
You will only have to do this setup procedure once to pair the naviPlay Headset with your mobile
phone. After this initial setup is complete, the connection between the naviPlay Headset and
your phone should be automatic.
1. IMPORTANT: Turn off both the naviPlay Headset and the naviPlay Adapter before attempting
pairing process. For best results, turn off other nearby Bluetooth-enabled devices also.
2. Press the POWER/Play/Pause button on the naviPlay Headset and hold it down for about eight
seconds until the status light quickly blinks amber and green. This puts the naviPlay Headset
in discoverable/pairing mode so that other Bluetooth devices can discover and pair to it.
3. Put your Bluetooth-enabled mobile phone into handsfree/headset pairing mode. Refer to the
documentation that came with your Bluetooth mobile phone for exact procedure and details.
4. Place the naviPlay Headset near the mobile phone. When prompted, enter “0000” for the
passkey to complete the pairing process. On your phone, select "naviPlay Stereo Headset" as
the device to connect/pair with.
When the connection process is complete, the status light on the naviPlay Headset blinks
green slowly, then alternates between slowly blinking amber and green. The naviPlay Headset
will now connect to the previously configured music source as well as your mobile phone.
If the pairing process fails the status light will change to constant red, then alternates
between slowly blinking amber and green. You can attempt the process again from step one
or check the TEN website for more information: www.tentechnology.com/support/
17 Using naviPlay Headset with Other Bluetooth-Enabled Devices