Texas Instruments 3138 155 232931 - Manual (Page 62)

CC2420
SWRS041B Page 62 of 89
Address Register Register type Description
0x0E SAES S AES Stand alone encryption strobe. SPI_SEC_MODE is not
required to be 0, but the encryption module must be idle. If not,
the strobe is ignored.
0x0F - - Not used
0x10 MAIN R/W Main Control Register
0x11 MDMCTRL0 R/W Modem Control Register 0
0x12 MDMCTRL1 R/W Modem Control Register 1
0x13 RSSI R/W RSSI and CCA Status and Control register
0x14 SYNCWORD R/W Synchronisation word control register
0x15 TXCTRL R/W Transmit Control Register
0x16 RXCTRL0 R/W Receive Control Register 0
0x17 RXCTRL1 R/W Receive Control Register 1
0x18 FSCTRL R/W Frequency Synthesizer Control and Status Register
0x19 SECCTRL0 R/W Security Control Register 0
0x1A SECCTRL1 R/W Security Control Register 1
0x1B BATTMON R/W Battery Monitor Control and Status Register
0x1C IOCFG0 R/W Input / Output Control Register 0
0x1D IOCFG1 R/W Input / Output Control Register 1
0x1E MANFIDL R/W Manufacturer ID, Low 16 bits
0x1F MANFIDH R/W Manufacturer ID, High 16 bits
0x20 FSMTC R/W Finite State Machine Time Constants
0x21 MANAND R/W Manual signal AND override register
0x22 MANOR R/W Manual signal OR override register
0x23 AGCCTRL R/W AGC Control Register
0x24 AGCTST0 R/W AGC Test Register 0
0x25 AGCTST1 R/W AGC Test Register 1
0x26 AGCTST2 R/W AGC Test Register 2
0x27 FSTST0 R/W Frequency Synthesizer Test Register 0
0x28 FSTST1 R/W Frequency Synthesizer Test Register 1
0x29 FSTST2 R/W Frequency Synthesizer Test Register 2
0x2A FSTST3 R/W Frequency Synthesizer Test Register 3
0x2B RXBPFTST R/W Receiver Bandpass Filter Test Register
0x2C FSMSTATE R Finite State Machine State Status Register
0x2D ADCTST R/W ADC Test Register
0x2E DACTST R/W DAC Test Register
0x2F TOPTST R/W Top Level Test Register
0x30 RESERVED R/W Reserved for future use control / status register
0x31-
0x3D
- -
Not used
0x3E TXFIFO W Transmit FIFO Byte Register
0x3F RXFIFO R/W Receiver FIFO Byte Register
R/W - Read/write (control/status), R - Read only, W – Write only, S – Command Strobe (perform action upon access)
Table 11. Configuration registers overview