TRANWO Technology 3010 - Manual (Page 18)

Troubleshooting Troubleshooting Troubleshooting Troubleshooting Troubleshooting
If you are not getting any signal at all If you are not getting any signal at all If you are not getting any signal at all If you are not getting any signal at all If you are not getting any signal at all
•
Check that the receiver is properly connected to the TV which you want to receive the signal
•
Check the power ON/OFF switches on the camera and receiver
•
Check power switches on the TV
•
Make sure power plugs are pushed all the way in.
•
Check all cable connections.
•
Check the CHANNEL switch on both camera and receiver are set to the same number
•
If you connect the receiver to a TV through an RF modulator, check that the TV is tuned to the
same channel as the TV Channel switch on the RF modulator (3 or 4)
If the signal is poor, or there is interference If the signal is poor, or there is interference If the signal is poor, or there is interference If the signal is poor, or there is interference If the signal is poor, or there is interference
•
Adjust the antennas orientation (see "Orienting Units for Optimal Performance", on page 15)
•
Change the channel on both camera and receiver and make them the same.
•
If there is a microwave oven in use in the path between the camera and receiver, remove the
microwave oven or turn it off
•
Make sure the camera and receiver are within range (up to 300 feet)
•
Check the channel dipswitch positions on the receiver
16