TP-Link TL-SL3226P - Manual (Page 21)

Cross Cable
The Switch (normal port) connects to the switch/hub/other equipments
(normal port).
Usually, the Straight Cable is required to connect to the switch (Uplink
Port) or NIC.
The following Figure shows the facture of the Straight Cable and the
Cross Cable.
Straight Cable
The Switch (Uplink port) or NIC connects to the switch/hub/other
equipments (normal ports).
Connector pin assignment
Contact MDI-II Signal MDI-X Signal
1 TX+ (transmit) RX+ (receive)
2 TX- (transmit) RX- (receive)
3 RX+ (receive) TX+ (transmit)
4 Not used Not used
5 Not used Not used
6 RX- (receive) TX- (transmit)
7 Not used Not used
8 Not used Not used
RJ-45 Connector pin assignment
Table A-1. The standard Category 3 cable, RJ-45 pin assignment
1 RX+
2 RX-
3 TX+
6 TX-
RX+ 1
RX- 2
TX+ 3
TX- 6
MDI-X MDI-X
1 TX+
2 TX-
3 RX+
6 RX-
RX+ 1
RX- 2
TX+ 3
TX- 6
MDI-II MDI-X
Figure A-3 Straight Cable
Figure A-4 Cross Cable
TL-SL3226P 24+2G Gigabit Managed Switch User's Guide TL-SL3226P 24+2G Gigabit Managed Switch User's Guide
System Configuration System Information System Name TL-SL3226PVXX
System Position New Location
Contact Administrator
Switch Parameter Assigned Managed Port All Ports
Broadcast Storm OFF
Filtering Mode
File transfer Transfers Type
File Name sl3226p.bin
TFTP Server 0.0.0.0
Ports Management Port Parameters State Enable
Port Security Disable
Flow Control Enable
Speed/Duplex Auto
Drop Untag Frm Disable
Drop NonMbr Frm Disable
Default VID 1
Update System File
Annex B Default Configuration of the switch