TP-Link TL-SL3226P - Manual (Page 7)

3.2 Connecting the Switch
3.2.1 Front Panel
There are 2 extension module slots, 24 10/100Mbps ports, one console
(RS232) port and LED indicators on the front panel of the TL-SL3226P.
Module Slot
The module slots can connect 100M/1000M module card and GBIC card.
24 10Base-T/100Base-TX RJ-45 ports
All ports can auto-negotiate between 10Mbps or 100Mbps and full or half-
duplex. You can configure the speed, duplex mode, flow control, broadcast
storm control and security control through kinds of manage-ment way such
as SNMP, Web, Telnet or Out-of-Band management.
There is one LED on each side of every port. Link/Act LED on the left is green.
100Mbps LED on the right is orange.
Console port
The Console port or RS232 port on the right of the front panel is the
!
!
!
connection port with PC when Out-of-Band management.
Power LED
Located between the console port and 24 normal ports, the power LED will
be always green when power on. Or else, please check the power
connection.
100Mbps LED (Speed LED)
When a normal port connects to 100Mbps equipment, the responding LED is
orange. An unlit LED indicates a connection speed of 10Mbps.
Link/Act (Connection LED)
The LEDs are lit when there is a secure connection to a device at any of the
ports.
The flash LED indicates data transmission at the responding port.
3.2.2 Rear Panel
The rear panel of the TL-SL3226P contains a power connector and a port for
ground connection.
Power connector
The AC power connector is a standard three-pronged connector that
!
!
!
!
Figure 3-2 Front Panel of the TL-SL3226P
Power
Slot 1 Slot 2
Link/Act
TX RX Act
FDX/Col
1000M
10/100M Console
17 19 21 23
18 20 22 24
9 11 13 15
10 12 14 16
1 3 5 7
2 4 6 8
100M
24+2G Gigabit Managed Switch
TL-SL3226P Link
Act
TL-SL3226P 24+2G Gigabit Managed Switch User's Guide TL-SL3226P 24+2G Gigabit Managed Switch User's Guide
Link/Act
Figure 3-3 one port of the TL-SL3226P
110-260V 110-260V 50-60Hz 0.6A 50-60Hz 0.6A ~
Figure 3-4 the Rear Panel of the TL-SL3226P