TC electronic SDN BHD x32 - Manual (Page 17)

15
The Integrator plug-in is automatically installed when the
TC Near control panel is installed.
Parameters
Lock
Green - indicates correct lock between the selected
external digital device and Digital Konnekt x32.
Red - indicates “no lock”. Check connections and
settings.
Device
Selects the connected digital devices you are setting up.
1st audio channel
Your DAW detects audio channels on the Digital Konnekt
x32 and label these automatically. As the Integrator acts
as a stereo plug-in interface between the DAW and
external stereo devices, you always select two channel
(by default). These are identified by the name of the first
channel. In the illustration on the previous page, channel
pair 9/10 is selected even though the label says “fw ch
9”.
When inserting Integrator on a mono track it still
occupies a pair of channels.
Calibrate
Integrating external digital devices will introduce a short
latency. But your host application can be set up to
compensate for this using the calibrate function in the
Integrator.
• Press CALIBRATE to measure the total roundtrip
latency including the latency within the external device.
The latency compensation feature of the host application
will then make sure to compensate for this latency.
This procedure should be carried out on each audio track
where Integrator is inserted.
INTEGRATOR