TC electronic SDN BHD x32 - Manual (Page 29)

Status
Various lock status indications can be given:
Internal Lock
Indicates that the system is locked to the Digital Konnekt
x32 unit set as clock master.
External Lock
Indicates that the system is locked to an external digital
device connected to the Digital Konnekt x32 set as clock
master.
No Reference
External sync on the Digital Konnekt x32 set as master is
unobtainable. Check connections and external device.
Versions
This section gives information on Control panel versions
and FireWire driver.
Check for updates
•
If the computer is connected to the Internet you may
check for updates by pressing “CHECK FOR
UPDATES”. You will be directed to the Konnekt
product page at www.tcelectronic.com
• Press “Click here to download the latest version” and
download the full installer.
• Run the installer.
Updating firmware
•
Once the installer has been run (see above), the
latest version of firmware is placed in the TC Near
folder on your hard disk.
• You will now need to update the firmware for each
Konnekt unit in the setup.
• Go to the “About page” for the unit you wish to
update.
Example
• Press UPDATE FIRMWARE and you will be directed
to the folder where the firmware is located.
Example
• Select the “xxx.bin” file with the highest number. This
is the latest released firmware.
• Now press “Open” and wait while the firmware is
being updated.
Reset to Default
The Reset to Default function will reset the selected
Konnekt unit to factory default settings for the currently
loaded software.
The software will not be degraded to previous
software versions and no presets are affected.
27