Tricity Bendix TBWD 1210 - Manual (Page 6)

1 Detergent dispenser drawer
2 Mains-on light
This light comes on when the On/Off button is pressed,
and goes out when it is pressed again.
3 On/Off button
Press this button to switch the machine on. Press it
again to switch the machine off.
Programme Option buttons
Depending on the programme, different functions can
be combined. These must be selected after choosing the
desired programme and before depressing the
Start/Pause button.
When these buttons are pressed, the corresponding pilot
lights come on. When they are pressed again, the pilot
lights go out.
If an incorrect option is selected, the corresponding
pilot light flashes for about 2 seconds and the message
Err is displayed.
4 Prewash button
The machine performs a prewash cycle at 30°C max.
The prewash cycle ends with a short spin at 650 r.p.m.
in programmes for Cottons and Synthetics, and with
emptying of the water for Delicates.
This option is not available with the Wool
and
Mini 30 programmes.
For use when washing heavily soiled laundry.
6
The Control Panel
1 2 3 4 5 9 6 7 8 10 11
12
13 14
1 2 0 0
Rinse
hold
Prewash
Wash
Rinse
Rinse hold
Drain
Spin
Drying
End
Start/
Pause Spin Prewash
Delay
start Quick On/Off
Half
load
Extra
rinse
Time
dry
Programme time
900
700
500
1200
TBWD 1210
A U T O W A S H
Programme
Drain
Off
Dry
Rinses
Spin
Wool
Cottons
Synthetics
Soak 30
40°
60°
40°
30°
30°
95°
60°
E60°
E40°
30°
E60°
40° Dry
Softener
Mini 30
30°
40°
Delicates
5 Spin button
Press this button to reduce the maximum speed of the
final speed proposed by the machine for the selected
programme or to select Rinse hold position.
The light corresponding to the selected spin speed
illuminates.
The following speeds are available for the different
fabrics:
• Cottons, linen: 500/700/900 max 1200 r.p.m.
• Synthetics and
Wool :
500/700 max 900 r.p.m.
• Delicates and Mini 30:
500 max 700 r.p.m.
The light corresponding to the selected spin speed
illuminates.
Rinse hold
When Rinse Hold option is selected, the last rinse
water is not emptied out, to prevent the fabrics from
creasing. When the programme has finished, the display
will show a flashing zero, the light of the
Start/Pause
button goes out, the Rinse Hold, the End pilot lights in
the progress display are alight and the door is locked to
indicate that the water must be emptied out.
To empty out water there are 2 possibilities:
• Select Drain programme:
The water is emptied out without spinning.
• Select Spin programme: reduce eventually the spin
speed by means of the relevant button and then
depress the
Start/Pause button.
The water is emptied out and the laundry is spun at
the selected spin speed.
Attention! Before selecting Drain or Spin
programmes, the selector dial has to be positioned on
Off (cancelling).