Tyan Computer TOLEDO S5520 - Manual (Page 52)

52
3.4.3 I/O Device Configuration
This setting allows you to configure I/O devices.
PhoenixBIOS Setup Utility
Main Advanced Security Power Boot Exit
I/O Device Configuration
Item Specific Help
Floppy disk controller
Serial port A:
Base I/O address:
Interrupt:
Serial port B:
Mode
Base I/O address
Interrupt:
[Enabled]
[Enabled]
[3F8]
[IRQ4]
[Enabled]
[Normal]
[2F8]
[IRQ3]
Configure using these
options:
[Disabled] No
configuration
[Enabled] User
configuration
[Auto] BIOS or OS
chooses configuration
(OS Controlled)
Displayed when
controlled by OS
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
Esc Exit ← → Select Menu Enter Select X Sub-Menu F10 Previous Values
Floppy disk Controller
This defines how the floppy disk controller is detected and configured.
Options: Disabled / Enabled / Auto
Serial Port A/B:
This defines how the serial port A/B is detected and configured.
Options: Disabled / Enabled / Auto
Base I/O Address:
Set the base I/O address for serial port A/B.
Options: 3F8 / 2F8 / 3E8 / 2E8
Interrupt:
Set the interrupt for serial port A/B.
Options: IRQ3 / IRQ4
Mode
Set the mode for serial port B.
Options: IR / Normal