TAO 90010 - Manual (Page 8)

2.3 Remote Control Battery Usage
• Place the remote control buttons facing down.
• Press the tabs against each other, and pull out the battery tray.
•
Place one CR2025 lithium battery on the tray with the “+” side facing up.
• Reinsert the tray.
2.4 Inserting Memory Cards
• Insert any compatible memory card with the front label facing the rear of the
frame. Do not force the memory card into the memory card slot.
• If you cannot easily insert the memory card, you may have inserted it incor-
rectly. The frame should detect the memory card automatically and display
images from the card, rather than the internal memory.
• The Digital Photo Frame is compatible with the following memory card for-
mats:
2.5 Main Menu.
• When selecting items on your Digital Photo frame, you have two options:
•
Use the arrow buttons on your remote control, and press enter.
• Use the arrow buttons your frame, and press play/pause.
• Press either the “Exit” button on your remote, or the menu button on your
frame to cycle to the main menu.
• Here you will be able to select photos, set the time, play music, or change
advanced settings.
5x7, 8x10 frames: See above.
Photo Clock: Not applicable.
Secure Digital Card ™(SD) Memory Stick ® (MS)
Multi Media Card ™(MMC) Compact Flash ® (CF)
Extreme Digital ™(XD) (adapter required) USB Flash Drive
5x7, 8x10 frames: See above.
Photo Clock: Not applicable.
Figure 2
Battery Replacement
Page 8
Tao
www.taoelectronics.com
4 Advanced Settings
4.1 Setup Menu
•
To enter the setup menu select the “Setup” option from the main menu using the arrow
buttons and play/enter.
4.2 Slide Interval
•
This option allows you to choose the time in between photos during your slide show.
•
You are able to choose a transition speed of either 5, 10, 30, or 60 seconds between
photos.
•
The factory setting transition speed is 5 seconds.
4.3 Show Time
•
This option allows you to turn the digital clock on or off.
•
The factory setting is “OFF”.
4.4 Show Calendar
•
This option allows you to turn the calendar on or off.
•
The factory setting is “OFF”.
4.5 Music Repeat
•
This options allows you to change the music playback mode.
•
“All” will play all of the songs, and then loop to the first song.
•
“One” will loop the selected song repeatedly.
•
“None” will play the song once only.
•
The factory setting is, “All”
4.6 Aspect
•
This option allows you to change the aspect ratio.
•
You can choose either 4:3, or 16:9.
•
The factory setting is 4:3.
4.7 Volume
•
This option allows you to change the speaker volume.
•
You can choose a numerical value where higher numbers are louder and lower numbers
are softer.
•
The factory setting is 6.
Page 13
Tao
Copyright ©2007 TAO Electronics, Inc. All Rights Reserved