Technicolor - Thomson TG784 - Manual (Page 39)

E-DOC-CTC-20080421-0010 v1.0 33
5 Telephony
5.4 Configuring the Telephony Service
Introduction
If you configured your Thomson Gateway using the Guided Installation , the telephony service will already be
configured by the Setup wizard.
If you choose to configure your Thomson Gateway manually or you still need to configure the telephony
service, you can follow the procedure below.
Requirements
Your Internet connection must be up and running before you can configure Internet telephony.
Procedure
Proceed as follows:
1 Assign Phone Numbers
2 Configure the Telephony Service
3 Enable the Telephony Service
Assign Phone Numbers
To configure your Internet SIP telephone numbers:
1 Browse to the Thomson Gateway Web Interface .
2 On the Toolbox menu, click Telephony.
3 In the Location bar , click Configure. Assign phone numbers to the ports. If you want to use the same
number for all ports, select Port ‘All’.
4 Click Apply.
Configure the Telephony Service
Proceed as follows to configure the telephony service:
1 Browse to the Thomson Gateway Web Interface .
2 On the Toolbox menu, click Telephony.
3 In the Location bar , click Expert configure.
4 Enter the IP address and the port number of the registrar, and the proxy, as provided by your ISP:
5 Click Apply.
Enable the Telephony Service
To enable the telephony service:
1 Browse to the Thomson Gateway Web Interface .
2 On the Toolbox menu, click Telephony.
The phone numbers are provided by your provider.