Technicolor - Thomson TG784 - Manual (Page 42)

E-DOC-CTC-20080421-0010 v1.0 36
5 Telephony
5.6 Telephony services
Introduction
Telephony services or supplementary services add extra functionality to your phone. Which supplementary
services that are available is determined by your service provider.
The following list gives an overview of the services that may be available:
3pty: three party call
Callreturn: to call back the last missed call
Ccbs: call completion on busy subscriber (automatic callback)
Cfbs: call forwarding on busy subscriber
Cfnr: call forwarding on no reply
Cfu: call forwarding unconditional
Clip: calling line identification presentation
Clir: calling line identification restriction
Clironcall: clir for only one call
ForcedFXO: switch to FXO (PSTN)
Hold: put an active call on hold
Mwi: message waiting indication
Transfer: call transfer between local ports
Waiting: incoming call while active call indication
Waitingoncall: call waiting active for only one call.
Checking which services that you can use?
To check which services you can use:
1 Browse to the Thomson Gateway Web Interface .
2 On the Toolbox menu, click Telephony.
3 In the Location bar , click Configure.
4 In the Pick a task list, click View Telephony Services.
5 Under Telephony Services, you can see the services that are supported by your provider.
Activating services
You can activate/deactivate supplementary services in two ways:
Via activation/deactivation codes, also referred to as service code commands.
Via the Telephony Configure page.
The activation/deactivation codes for a specific supplementary service is displayed in the overview.
For example, to activate Call Hold dial *94; to deactivate the service dial #94.