Tekkeon MP3450-10 - Manual (Page 8)

6
Connect the Power Output Cord
1. Plug the large end of the power output cord into the DC OUT jack on the end of myPower ALL Plus.
(If you have previously selected a voltage, the voltage selection will be returned to the lowest setting.)
Adjust the Voltage Level
1. Locate the voltage specification for your portable device. This can be
found on the device power adapter label or device specification label
which typically is found on the bottom of the unit.
(If available, use the voltage specification shown on the power adapter.)
2. Slide the power switch to ON. The 5V voltage indicator will turn on to
indicate that the voltage is set to the lowest setting.
3. Press the voltage selector until the voltage indicator for your voltage
selection (5, 6, 7.5, 9, 12, 14, 16, 19) turns on. Set the voltage output to
the selection that is equal to, or one step lower or higher (whichever is
closer) than the voltage identified for your device. For example, if your
device requires 6V, set the voltage to 6V. If you device requires 7.2V,
set the voltage to 7.5V. The voltage will be automatically locked after a
device is connected.
4. To change the voltage, disconnect the output cable from the device, and select a new voltage.
The voltage will be automatically locked after a device is connected.
CAUTION: It is important to set the voltage selector NO MORE than one step higher than the voltage
requirement for the portable device as an incorrect setting may prevent myPower ALL Plus from working
with your device, or may harm your device in the rare instance that the device accepts the higher voltage.
However, for all devices, adjusting the voltage ONLY one step higher than required will not harm the
device.
Sample Power Adapter
Label.