Uniden DX15686 Series - Manual (Page 13)

2
• Make sure the wall material is capable of supporting the weight of the base and handset.
• Use #0 screws (minimum length of -3/8 inches) with anchoring devices suitable for the wall
material where the base unit will be placed.
) Insert two mounting screws into the wall (with their appropriate anchoring device), 3-5/6
inches apart. Allow about /8 of an inch between the wall and screw heads for mounting the
phone.
2) Refer to steps  through 5 on page  to mount the telephone.
Installing.the.Belt.Clip
To.attach.the.belt.clip
Insert the belt clip into the holes on each side of the handset. Press down until it clicks.
To.remove.the.belt.clip
Pull both sides of the belt clip to release the tabs from the holes.
Headset.Installation
Your phone may be used with an optional headset. To use this feature, insert the headset plug into
the headset jack. Your phone is ready for hands-free conversations. (Headsets may be purchased
by visiting our website at www.uniden.com or by calling our Parts Department. See back cover
page.)