Ultratec INTELE-MODEM - Manual (Page 28)

APPENDIX B: MODEM TERMINOLOGY
ASCII code
ASCII stands for American Standard Code for Information Interchange. ASCII is the
standard communication code used by computers and ASCII TTYs in the United States
and Canada. When modems use ASCII code to communicate, they use a carrier signal.
After dialing a number, the calling modem listens for an answer tone. When it hears one,
it puts out an originating tone. This tone is maintained throughout the conversation. If at
any time the carrier tone is dropped, the modem hangs up.
Baud rate
The speed a code travels from one place to another in bits per second (bps). The baud rate
for Baudot code is either 45 or 50 bps. The baud rate for ASCII code depends on the
modem, and can be 110, 300, 1200, 2400, or higher.
Baudot code
Baudot code is the code used by most TTYs to communicate. Originally, Baudot code was
used by Teletype machines in the United States to send telegrams. Baudot communication
does not use a carrier tone. Tones are only sent when actual communication takes place.
At other times, the line is silent.
Bit
The smallest piece of a communication code. An electronic signal that TTYs and computers
can send and receive.
Code
A way to organize bits into meaningful information. ASCII and Baudot codes organize bits
differently. Each letter, number, or symbol in ASCII code is described by 7 bits of
information. In Baudot code, each character is described by 5 bits.
Duplex, full- or half-
Communication settings that determine how your computer displays the characters that
are sent and received. Full duplex means that what you type is sent to the other computer
or TTY and then sent back to be displayed on your computer monitor. Half duplex means
that what you type is simultaneously sent to the other computer and to your computer
monitor. See the Problems and Solutions section on page 21 for what to do if you have
double characters or no characters at all on your screen.
Modem
Modems allow computers and TTYs to communicate by telephone. A modem translates the
electronic signals of ASCII or Baudot code into sounds, and then sends the sounds over the
telephone line. The modem for a computer or TTY determines what codes can be
communicated (ASCII or Baudot), and how fast the codes can be sent and received (baud
rate). TTYs have built-in modems.
Originate and answer
Originate and answer are ASCII code communication settings that determine how your
TTY or computer sends and receives signals. When computers and TTYs talk to each
other, one must be set to originate and the other to answer. When placing a call, a modem
automatically uses originate mode. When answering a call, it uses answer mode.
24 • APPENDICES