Ultratec INTELE-MODEM - Manual (Page 7)

HOW TO SET UP YOUR INTELE–MODEM
Equipment you need ________________________________________
The place where you set up your computer and modem should have several electrical
outlets and a telephone wall jack within five or six feet.
CAUTION: The Intele–Modem is designed for standard telephone lines, and it
will not work with a computerized telephone system such as a PBX.
Connecting the modem to a non-standard phone line may damage your
telephone system or Intele–Modem, and will void the warranty. If you have
questions, contact your phone system installer.
The Intele–Modem.
The Intele–Modem comes with AC power and telephone cords.
A personal computer or a computer terminal or workstation.
You can use an IBM or IBM-compatible, Macintosh or other brand of computer. You can
also use a terminal designed for connection to a mainframe or network, as long as you
have the right software. The serial com port setting must be: 300 BAUD, 8N1, No Flow
Control (No Software Flow Control).
A telephone line.
Don’t use a party line or a line that’s part of a multiple-phone system, such as a PBX. Use
a standard, analog telephone line. A telephone is optional.
A communications software program.
There are many different programs that will work. Any program that provides for
“terminal emulation” will do. If in doubt, ask your computer store or microcomputer user
group for the software that works best with your computer.
A cable to connect your Intele–Modem to your computer.
You need a cable with a connector for the modem on one end and the right connector for
your computer on the other. Computers have many different kinds of connectors. Standard
cables for IBM-compatible and Macintosh computers are available from Ultratec.
Setting up _________________________________________________
1. Be sure the Intele–Modem “ON” switch is pushed to the right (the off
position). The switch is on the back panel. Plug the AC power cord into the
PWR (power) jack. Plug the other end into an electrical outlet.
2. Plug one end of the Intele–Modem computer cable into the RS-232C port on
the back of your Intele–Modem. Plug the other end into the serial port of
your computer (sometimes called the RS–232C port).
3. Telephone hook-up. Plug the telephone cord into either one of the telephone
jacks on the back of the Intele–Modem. Plug the other end of the cord into a
telephone wall jack. To connect a phone to the same line, plug the telephone
cord into the second jack on the Intele–Modem’s back panel.
HOW TO SET UP YOUR INTELE-MODEM • 3
ON
LINE PHONE RS-232C REMOTE VOLUME PWR
Intele–Modem
back panel