Uniden BEARCAT BC95XLT - Manual (Page 41)

41
Special Features
Using Close Call RF Capture
To turn on the Close Call feature, press Func + C
once except in WX search, band select, or program
mode.
C appears. Every 2 seconds, the scanner
checks for frequencies in the range you specified in
“Setting the Close Call Options” on Page 38, if it
isnot already stopped on a transmission.
Notes:
• Set the squelch tight (where only strong signals
are received) while using Close Call.
• To continue scanning normally while the Close
Call feature is working, simply press Scan twice.
When the scanner finds a frequency, it sounds the
alert you specified in “Setting the Close Call
Options” on Page 38, and Found flashes. Press any
key to confirm the displayed frequency. Press Scan
to resume scanning. Or press or while the
frequency and f appear to select the band where
you are searching.
To turn on the Close Call feature and turn off normal
scanning, press Func +
C twice. C flashes.
To turn off Close Call and turn on normal scanning,
press Func +
C three times. C disappears.
Chain Search
This feature lets you search through preset
frequency ranges. You can also change each range
to a range you set. There are three modes within
this feature: chain search mode, chain search hold
mode, and program band select mode.