Uniden BC785D - Manual (Page 55)

ID Scan Mode
1. Press SCAN to begin scanning the lists you have
programmed.
If you haven't programmed more than 2 IDs, ERROR
appears on the display.
Hint: Press and hold RSM for 2 seconds, the scanner will move to the next trunking bank.
2. To remove a Scan List from active scanning, press the number of the Scan List on your
keypad.
The Scan List indicator turns Off, and the IDs in that list are not scanned.
Note: One Scan List must always be active. If you try and deactivate all the Scan Lists,
Scan List 1 will automatically be active.
3. To restore a Scan List to active scanning, press its number again.
4. Press SRCH to return to Trunk Tracking Search mode.
☞ Remember! When you press and hold TRUNK for 2 seconds, you can switch Trunk
Tracking modes (Scan or Search).
Note: • While ID Scanning, to change all trunking banks to the Service Search mode, press
SRVC.
• Selecting a Scan List is also possible in the Menu mode. (LTR only)
• ID SCAN appears on the display during Trunk Scan instead of simply SCAN.
ID Scan Hold Feature
If you want to stop on a ID during ID scanning, press ▲/HOLD.
If you want to resume scanning, press RSM.
To directly access a specific channel:
There are several ways to access a specific ID quickly.
1. Press ▲/HOLD.
2. By using the keypad or rotating the VFO enter the ID
location number (See page 48).
3. Press ▲/HOLD again.
Trunked Search
Once you have programmed all the frequencies for a trunked system, Search will let you
immediately start hearing transmissions.
51
ID SCAN
867.9875 NFM
List 1234567890
M1-1:4128
867.8375 NFM
ID Tag
LIST Tag
C1000
0000.0000
Bank 10
BC785D 11/8/2 1:01 PM Page 51